Ultimate Strap Instructions

1. Net should measure at least 38 inches at the center prior to strap installation for best result. Anchor must be below surface of court. If anchor is above ground use The Slam or The Player Straps. Snap clip into court anchor with Metal tab end of strap towards opposite side of net, and non-metal tab on your side of net. Then bring metal tab end of strap over top of net and down until tab touches court surface.

2. Hold very end of the metal tab to court surface, pull up on free end (non-metal tab) of strap. This will pull net down until sewn measuring mark is even with top of net.

3. Firmly press straps together along entire length of matching hook and loop swatches.

4. Important: Strap measures correct net height when metal tip is touching the court surface, and  sewn mark rests atop the net.

5. Feed free (non-tab) end of strap through top of slide buckle, towards net. Bring it over buckle's center bar and back through lower slot of buckle. Pull down on free end of strap until strap is taut.

6. Do not over tighten and cause slack in measured main strap. Firmly press second matching hook and loop swatches together. Next, button straps on both sides of net together through net. Finally, Pull upward firmly on the top of the net to loosen any slack that may still exist in the strap. It's that simple!

Experts on call Monday - Sunday 10 AM EST - 7 PM EST
Call 1-910-352-5805